Science of Sintering
EXECUTIVE DIRECTOR FOR PUBLISHING AND JOURNAL
Professor V. V. Mitić
University of Niš, Faculty of Electronic Engineering
Aleksandra Medvedeva 14, 18000 Niš, Serbia
This email address is being protected from spambots. You need JavaScript enabled to view it.
CO-EDITORS-IN-CHIEF
Professor D. Uskoković
Institute of Technical Sciences, Serbian Academy of Sciences and Arts
Knez Mihailova 35/IV, 11000 Belgrade, Serbia
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor Z. S. Nikolić
University of Niš
Univerzitetski trg 2, 18000 Niš, Serbia
This email address is being protected from spambots. You need JavaScript enabled to view it.
ASSOCIATE EDITOR
Dr. Olivera Milošević
Institute of Technical Sciences, Serbian Academy of Sciences and Arts
Knez Mihailova 35/IV, 11000 Belgrade, Serbia
This email address is being protected from spambots. You need JavaScript enabled to view it.
EDITORIAL ASSOCIATES
Dr. Nina Obradović, This email address is being protected from spambots. You need JavaScript enabled to view it.
Dr. Darko Kosanović, This email address is being protected from spambots. You need JavaScript enabled to view it.
EDITORIAL BOARD SECRETARIAT
Dr. S. M. Radić Ristić, This email address is being protected from spambots. You need JavaScript enabled to view it.
Dr. Suzana Filipović, This email address is being protected from spambots. You need JavaScript enabled to view it.
Dr. Vladimir Blagojević, This email address is being protected from spambots. You need JavaScript enabled to view it.
REGIONAL EDITORS
Regional Editors for Europe
Dr. D. Suvorov
Institute “Jožef Stefan”
Jamova 39, 1000 Ljubljana, Slovenia
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor V. V. Mitić
University of Niš, Faculty of Electronic Engineering
Aleksandra Medvedeva 14, 18000 Niš, Serbia
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor Emeritus A. Maričić
Faculty of Technical Sciences
Svetog Save 65, 32000 Čačak, Serbia
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor Đordje Janaćković
University of Belgrade, Faculty of Technology and Metallurgy
Karnegijeva 4, 11000 Belgrade, Serbia
This email address is being protected from spambots. You need JavaScript enabled to view it.
Dr. W. Wlosinski
Warsaw University of Technology
Pl. Politechnicki 1, 00661 Warszawa, Poland
This email address is being protected from spambots. You need JavaScript enabled to view it.
Dr. J. M. Chaix
Laboratorie de Thermodynamique et de Physico-Chimie Metallurgiques
ENSEG BP75, F-38402 Saint Martin d’Heres, France
This email address is being protected from spambots. You need JavaScript enabled to view it.
Regional Editors for America
Dr. J. E. Blendell
School of Materials Engineering, Purdue University
501 Northwestern Ave., West Lafayette, IN 47907, USA
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor R. M. German
College of Engineering, San Diego State University
55000 Campanile Drive, San Diego, CA 92182-1326
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor Yu. Gogotsi
Drexel University, ept. of Materials Engineering
LeBow Bldg., Room 431, 3141 Chestnut St. Philadelphia, PA 19104 USA
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor E. A. Olevsky
Dept. of Mechanical Eng. College Of Engineering, San Diego State University
3500 Campanile Drive, Sand Diego, CA 98182-1323, USA
This email address is being protected from spambots. You need JavaScript enabled to view it.
Dr. M. Singh
Ohio Aerospace Institute, Mail Stop 106-5
NASA Glenn Research Center
Clevelenad, OH 44135 USA
This email address is being protected from spambots. You need JavaScript enabled to view it.
Dr. M. Kakazey
The Autonomous University of the State of Morelos
Av. Universidad, 1001 Cuernavaca, Mexico
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor B. Vlahović
NCCU, USA
This email address is being protected from spambots. You need JavaScript enabled to view it.
Regional Editors for Asia, Africa and Australia
Professor M. P. Dariel
Department of Materials Engineering, Ben-Gurion University
Beer-Sheva, Israel
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor Li Nan
Wuhan University of Science and Technology
Department of Materials Science and Engineering
947, Heping Dadao, Quinshan, Wuhan, Hubei 430081, P. R. China
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor S.- J. L. Kang
Dept. Materials Sci. and Eng.
Korea Advanced Institute of Science and Technology
Daejeon, 305-701, Republic of Korea
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor G. S. Upadhyaya
Deptartment of Materials & Metallurgical Engineering
Indian Institute of Technology
Kanpur-208016, India
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor F. Wakai
Secure Materials Center, Materials and Structures Laboratory
Tokyo Institute of Technology, Japan
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor R. Watanabe
Tohoku Polytechnic College, Aomori
171-2 Kitsuneno, Iizume, Goshogowara, Aomori, 037-0002, Japan
This email address is being protected from spambots. You need JavaScript enabled to view it.
Professor M. Yoshimura
Department of Materials Science and Engineering
National Cheng Kung University
No. 1, University Road, Tainan 70101, Taiwan
This email address is being protected from spambots. You need JavaScript enabled to view it.